Workshop examples

Completed workshop examples.

Each project below uses genuine workshop photographs and records the print settings, cleanup process and finishing applied to the completed piece.

90mm Runic Ruins base shown from the selected opening angle

View 01 / 09

Workshop example 01

90mm Runic Ruins base

The 90mm Runic Ruins base is a custom sculpt created as a detailed display base. It was printed at 0.03 mm layer height and cleaned using the workshop’s standard three-stage wash process. A light brush finish was then applied to remove stubborn support remnants and reduce visible support scarring.

Project type: Custom sculpt
Subject: 90 mm runic ruins display base
Layer height: 0.03 mm
Cleanup: Standard three-stage wash process
Finishing: Light brush finish

View 01 / 04

Workshop example 02

Bind Rune

The Bind Rune is a custom sculpt inspired by traditional Norse bind runes, where multiple runes are combined into a single symbol to express layered meaning, intent or protection. This piece was printed at 0.03 mm layer height and cleaned using the workshop’s standard three-stage wash process. It was then primed and hand painted for use as a decorative display piece.

Project type: Custom decorative sculpt
Subject: Norse-inspired bind rune plaque
Layer height: 0.03 mm
Cleanup: Standard three-stage wash process
Finishing: Primed and hand painted

Korr'Vaxx Duskvale viewed from the selected showcase angle

View 01 / 09

Workshop example 03

Korr'Vaxx Duskvale

Korr'Vaxx Duskvale is a custom sculpt of my personal Dungeons & Dragons character: a raven-variant Aarakocra artificer with extensive damage to his left wing, presented on a 40 mm base. It was printed at 0.03 mm layer height and cleaned using the workshop’s standard three-stage wash process. No additional brush finishing was applied, so very small support traces may remain in areas not fully addressed during standard cleanup.

Project type: Custom character sculpt
Subject: Raven-variant Aarakocra artificer on a 40 mm base
Layer height: 0.03 mm
Cleanup: Standard three-stage wash process
Finishing: No additional brush finishing

Every model is different

Examples demonstrate the process, not an automatic promise for every file.

Scale, orientation, supports, wall thickness and the supplied geometry are reviewed before a result is agreed.

Begin a commission query →